UKVIN Group technical guides / Printing and design
Checking print and cut quality
A finished label should be inspected for both correct data and usable physical construction. Good colour alone is not enough.
Technical considerations
Check dimensions, edge finish, print contrast, registration of print to cut line, adhesion and pack count. Personalised information needs an independent source check.
Application example
A batch can pass a visual colour check but fail because one serial number was repeated.
What to check
- Inspect samples
- Check data list
- Record release approval
Before requesting a quotation
Provide dimensions in millimetres, material or surface type, intended printing equipment if relevant, cut shape, quantity and the conditions the finished label will face. For variable information, supply an approved source list and confirm whether a proof is needed. If a component is legally required or factory-certified, seek the responsible issuer's instructions rather than assuming blank label stock can replace it.
Limitations
These design principles apply to independent identification and label materials. They do not constitute vehicle type approval or permission to reproduce manufacturer-controlled plates, marks or identity data. UKVIN Group provides unbranded materials and aims to verify appropriate personalised-label requests.
Identification label printing guide · Measuring guide · All UKVIN Group guides